Making a steel lathe chuck plate.
#8
(04-01-2012, 04:03 PM)EdAK Wrote: Bob,

What brand of MIG wire do you use?

Thanks,
Ed

HTP i get off ebay http://www.ebay.com/itm/2-10-lb-Rolls-ER...27be5cfd0c ...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
RE: Making a steel lathe chuck plate. - by EdK - 04-01-2012, 02:17 PM
RE: Making a steel lathe chuck plate. - by EdK - 04-01-2012, 04:03 PM
RE: Making a steel lathe chuck plate. - by aametalmaster - 04-01-2012, 04:14 PM
RE: Making a steel lathe chuck plate. - by EdK - 04-01-2012, 04:24 PM
RE: Making a steel lathe chuck plate. - by EdK - 04-01-2012, 05:28 PM



Users browsing this thread: 1 Guest(s)