plastic welding

[kenne]

(06-22-2014, 10:50 AM)ETC57 Wrote: Hi all,
Has anybody had any experience with welding plastic?
My pressure washer has one of those cheesy plastic two piece gas tanks and the seam has separated about 2" worth, now I can't put more than half a tank of fuel in it or it starts leaking out the side of the tank!
I sure do miss metal gas tanks.

Jerry

This is the welder in question , I have used it about 4 times with varying success , I repaired a rear bumper on my wifes caddy with it as they wanted 4500.00 to replace it (including paint) . That one went well , matter of fact only one didn't really do well , that was because I used the wrong filler . Anyway they are about $40.00-$50.00 at Harbor Freight .... Hope this helps , Good Luck !