Licking my Wounds Lathe Rebuild Project
#41
Why not do as I said some while back - arrange a pair of axles and run the gears outside the head stock - see how they run. Arrange a load on the shaft - see how they run. Abuse them a bit - see how they run - THEN take decisions whether to replace or not dependent on the facts that you ascertain rather than your fears.
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:


Messages In This Thread
RE: Licking my Wounds Lathe Rebuild Project - by awemawson - 07-06-2014, 12:28 PM



Users browsing this thread: 2 Guest(s)