MetalworkingFun Forum › Machinery › Lathes v
Wade Turret Lathe

Thread Modes
Wade Turret Lathe
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
The following 1 user Likes Mayhem's post:
jroadman (08-02-2014)
#3
08-02-2014, 07:57 AM
That is an interesting looking lathe. I've seen people use automotive timing belts on flat pulleys, turning them 'inside out'. I look forward to seeing your progress on this.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Wade Turret Lathe - by jroadman - 08-01-2014, 10:54 PM
RE: Wade Turret Lathe - by stevec - 08-02-2014, 06:06 AM
RE: Wade Turret Lathe - by jroadman - 08-02-2014, 09:59 AM
RE: Wade Turret Lathe - by Mayhem - 08-02-2014, 07:57 AM
RE: Wade Turret Lathe - by Dr Stan - 08-10-2014, 11:25 AM
RE: Wade Turret Lathe - by EdK - 08-02-2014, 08:12 AM
RE: Wade Turret Lathe - by Arbalest - 08-02-2014, 11:33 AM
RE: Wade Turret Lathe - by jroadman - 08-04-2014, 01:09 PM
RE: Wade Turret Lathe - by Shawn - 08-09-2014, 03:35 PM
RE: Wade Turret Lathe - by raykehrhan - 12-18-2014, 11:06 PM
RE: Wade Turret Lathe - by krv3000 - 12-19-2014, 06:22 PM
RE: Wade Turret Lathe - by jroadman - 12-22-2014, 10:31 PM



Users browsing this thread: 1 Guest(s)