[PROJECT] Spin Indexer Tailstock

[EdK]

Next I need to finish machining the body to accept the center. I'm not sure what the best way is to hold it for machining so I'm looking for suggestions. The first picture shows the top view and the second the front view. In the front view, the top line intersection is where I need to bore a .930" hole all the way through both sides of the body. That hole needs to be accurately in line with the rectangular cut-out seen at the bottom of the body. That cut-out gets a key mounted in it to key the tailstock to the mill table slot. The diameter of the body is 3.25", if that helps.

Ed