|
Toolpost lock nut
|
(08-19-2014, 09:55 PM)PixMan Wrote: I might consider making one for my Dorian CA size toolpost, but concerned that I'd need a very long handle to apply the forces I've needed to hold it from rotating around You could use a thrust washer Ken, that will increase the force  Here's a pic http://www.metalworkingfun.com/showthrea...37#pid1037  DaveH Thanks given by: schor
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Toolpost lock nut - by schor - 08-19-2014, 05:32 PM
RE: Toolpost lock nut - by PixMan - 08-19-2014, 09:55 PM
RE: Toolpost lock nut - by schor - 08-19-2014, 10:39 PM
RE: Toolpost lock nut - by DaveH - 08-19-2014, 11:12 PM
RE: Toolpost lock nut - by schor - 08-19-2014, 11:51 PM
RE: Toolpost lock nut - by PixMan - 08-20-2014, 06:30 AM
RE: Toolpost lock nut - by stevec - 08-20-2014, 09:17 AM
RE: Toolpost lock nut - by Mayhem - 08-20-2014, 07:37 AM
RE: Toolpost lock nut - by DaveH - 08-20-2014, 09:23 AM
RE: Toolpost lock nut - by DaveH - 08-20-2014, 09:30 AM
RE: Toolpost lock nut - by stevec - 08-20-2014, 11:09 AM
RE: Toolpost lock nut - by DaveH - 08-20-2014, 11:33 AM
RE: Toolpost lock nut - by DaveH - 08-20-2014, 12:06 PM
RE: Toolpost lock nut - by DanH - 06-28-2015, 02:03 PM
RE: Toolpost lock nut - by the penguin - 06-28-2015, 05:26 PM
RE: Toolpost lock nut - by Hopefuldave - 06-28-2015, 06:27 PM
RE: Toolpost lock nut - by donray0 - 07-09-2015, 09:27 AM
RE: Toolpost lock nut - by EdK - 07-09-2015, 04:27 PM
|
