just a lil tap
#11
i think you will need both pears of glasses on john to see 2mm
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#12
(09-14-2014, 05:15 PM)krv3000 Wrote: i think you will need both pears of glasses on john to see 2mm

And Hubble Big Grin

Nice going Bob Smiley-signs107


Rob
Reply
Thanks given by:
#13
As usual, Graemlin

Ed
Reply
Thanks given by:
#14
hi got a bit more dun set them up in the 4 jaw chuck and turned dawn one end to 8.5mm then a cup-er and sum chocolate stopped work


Attached Files Thumbnail(s)
       
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#15
Looking good Bob .


Is that were my Toblerone went to lol


Rob
Reply
Thanks given by:
#16
yep Rotfl
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#17
Fat GIT !  Big Grin


Rob 
Reply
Thanks given by:
#18
hi all well i have finisht off the taps still sum work to do on them two need bowls on the top the other 4 need elbows on the frunt and all need drilling and taping m4 to fit on to the cilinders pics


Attached Files Thumbnail(s)
                   
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#19
Very nice Mate
Reply
Thanks given by:
#20
I was examining these taps in person the other day and they look better than in these photos ........... as you would expect from wor Bob , a top class job Graemlin

 Cheers Mick
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)