09-15-2012, 07:55 AM
No embarrassment required,
if you try that is.
To all those others too scared to give it ago,
Shame, Shame, Shame,
But seriously, give it a go, post the results, and I'm sure we can give some feed back, It wouldn't hurt to note down the welding settings used on each run and the specs for the machine and consumables as well.
Regards
Rick
if you try that is.To all those others too scared to give it ago,
Shame, Shame, Shame,But seriously, give it a go, post the results, and I'm sure we can give some feed back, It wouldn't hurt to note down the welding settings used on each run and the specs for the machine and consumables as well.
Regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.