Help Welding a Welder Cart

[Highpower]

(09-15-2012, 08:34 PM)Mayhem Wrote: Whenever I replace a spool of wire, I pass the wire through an ear plug (the squishy disposable ones) and then feed it into the feed rollers. It prevents the wire from introducing any crap into the liner. This isn't my own idea, it was suggested to me by a welding tech when I had my liner replaced a few years back.

Some guys use a block of Scotch-Brite pad or the "high-tech" cleaning pads that most of the welding supply stores carry.
MIG wire cleaning pad

I find using clean wire and blowing out the cable liner occasionally works too.