MetalworkingFun Forum › Machining › Projects v
Wood Lathe Exert

Thread Modes
Wood Lathe Exert
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,795
Threads: 183
Joined: Jun 2012
Location: Farmington Hills, Michigan
The following 1 user Likes TomG's post:
f350ca (10-09-2014)
#4
10-09-2014, 06:39 PM
It's always best not to remove the fixture thread, but if you have to, like Greg suggested to use it as a gauge, be sure to turn two diameters on it to help in realigning it. You need to be sure it isn't running out or wobbling on axis.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Wood Lathe Exert - by solidedge - 10-09-2014, 03:24 AM
RE: Wood Lathe Exert - by dallen - 10-09-2014, 04:16 PM
RE: Wood Lathe Exert - by f350ca - 10-09-2014, 06:21 PM
RE: Wood Lathe Exert - by TomG - 10-09-2014, 06:39 PM
RE: Wood Lathe Exert - by solidedge - 10-10-2014, 01:52 AM
RE: Wood Lathe Exert - by EdK - 10-10-2014, 05:11 AM
RE: Wood Lathe Exert - by TomG - 10-10-2014, 07:24 AM
RE: Wood Lathe Exert - by solidedge - 10-13-2014, 09:51 AM
RE: Wood Lathe Exert - by solidedge - 10-13-2014, 09:55 AM
RE: Wood Lathe Exert - by solidedge - 10-14-2014, 03:03 PM



Users browsing this thread: 1 Guest(s)