A lean-to
#21
Dave,

How deep are the holes?

Ed
Reply
Thanks given by:
#22
Those posts ARE galvanised I trust ?
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:
#23
(10-18-2014, 12:31 PM)EdK Wrote: Dave,

How deep are the holes?

Ed

The holes are 450 x450 x450mm deep - (18" x 18" x 18" deep).
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#24
(10-18-2014, 12:48 PM)awemawson Wrote: Those posts ARE galvanised I trust ?

Nah Smile  given a coat of etch primer.
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#25
Concreted in the remaining two posts.
Also laid some concrete edging 'blocks'

   

   

   

   

Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#26
I need to allow the concrete to cure for about 5 days before I take down the supports.
Time for a rest Smiley-dancenana 
Smiley-eatdrink004 
DaveH
Reply
Thanks given by:
#27
How on earth do you keep things so neat and tidy Dave? You absolutely amaze me. If i tried something like that there would be piles of dirt, loose concrete and tools scattered everywhere! Smiley-eatdrink004 

You have a big industrial piping bag for concrete don't you?  Big Grin
Willie
Reply
Thanks given by:
#28
I tend to clean up before I take the photo's Smile 
Also if I leave all the mess I end up falling over or fall off the step ladder Big Grin 
Smiley-eatdrink004 
DaveH
Reply
Thanks given by:
#29
(10-19-2014, 09:52 AM)Highpower Wrote: You have a big industrial piping bag for concrete don't you?  Big Grin

I wish Smile  just mix a little at a time in the wheelbarrow.
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#30
Took the supports down, the posts didn't fall down Rotfl

   

   

All nicely in line Smiley-dancenana

   

Smiley-eatdrink004
DaveH
Reply
Thanks given by:




Users browsing this thread: 3 Guest(s)