My birthday vise
#11
Built just like my 2 Kurt 6" Anglock vises from what I can see.

I had a Chinese made 6" copy that I took apart to look at and found they didn't bother to machine the reverse angle and put a hemispherical spot and half-ball piece in there. Another reason I had disassembled it was that I found it was .002" out of parallel on the sliding surfaces of the base when it was mounted on it's swivel base. I checked it again without the swivel base and it was within a 1/2 thousandth of an inch in the 5" sweep.

I had paid $60 for it and sold it off for the same after I got my second Kurt. One is a D675, the other a D60. Both are nearly dead flat. I have no swivel bases for them but don't need one because I can just use the Prototrak control to cut an angle.
Reply
Thanks given by:


Messages In This Thread
My birthday vise - by JScott - 10-28-2014, 01:26 PM
RE: My birthday vise - by Highpower - 10-28-2014, 03:47 PM
RE: My birthday vise - by EdK - 10-28-2014, 04:07 PM
RE: My birthday vise - by doubleboost - 10-28-2014, 07:10 PM
RE: My birthday vise - by kenne - 10-28-2014, 08:03 PM
RE: My birthday vise - by JScott - 10-29-2014, 10:55 AM
RE: My birthday vise - by Shawn - 10-29-2014, 11:03 AM
RE: My birthday vise - by JScott - 10-30-2014, 10:20 AM
RE: My birthday vise - by Dr Stan - 10-30-2014, 12:25 PM
RE: My birthday vise - by JScott - 10-30-2014, 12:43 PM
RE: My birthday vise - by PixMan - 10-30-2014, 09:36 PM
RE: My birthday vise - by JScott - 11-10-2014, 01:48 PM
RE: My birthday vise - by PixMan - 11-10-2014, 04:18 PM
RE: My birthday vise - by Shawn - 11-15-2014, 03:17 AM



Users browsing this thread: 1 Guest(s)