MetalworkingFun Forum › Machining › General Metalworking Discussion v
VFD Question

Thread Modes
VFD Question
f350ca Offline
Senior
*****
Posts: 3,002
Threads: 51
Joined: Apr 2012
Location: Ontario
#6
12-17-2014, 12:38 AM (This post was last modified: 12-17-2014, 12:39 AM by f350ca.)
When you set the VFD to ramp up the speed, how does it do it? By reducing the voltage or by bringing up the frequency?
The only load the motor would have on start up would be weight of the blank, i.e. building momentum.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
VFD Question - by f350ca - 12-14-2014, 10:10 PM
RE: VFD Question - by stevec - 12-15-2014, 08:07 AM
RE: VFD Question - by 12345678910 - 12-16-2014, 08:32 PM
RE: VFD Question - by oldgoaly - 12-16-2014, 11:05 PM
RE: VFD Question - by dallen - 12-16-2014, 11:35 PM
RE: VFD Question - by f350ca - 12-17-2014, 12:38 AM
RE: VFD Question - by dallen - 12-17-2014, 01:36 AM
RE: VFD Question - by Terry S - 12-17-2014, 10:55 AM
RE: VFD Question - by Terry S - 12-17-2014, 11:10 AM
RE: VFD Question - by oldgoaly - 12-17-2014, 12:58 PM
RE: VFD Question - by f350ca - 12-17-2014, 02:26 PM
RE: VFD Question - by stevec - 12-18-2014, 09:34 AM
RE: VFD Question - by f350ca - 12-18-2014, 10:11 AM
RE: VFD Question - by f350ca - 01-16-2015, 09:32 PM



Users browsing this thread: 1 Guest(s)