[PROJECT] Clamp Knurling Tool

[TomG]

(01-01-2015, 12:10 PM)EdK Wrote:

(01-01-2015, 12:05 PM)TomG Wrote: Does it make that pattern feeding in both directions? If so, it's possible that there isn't enough relief on the cutter and it's dragging behind the cutting edge. Also, what alloy is the steel? If it's 1018, that might be a pretty good finish.

Tom

Tom,

 It is 1018.

Thanks,
Ed

Yup, that's as good as you are going to get. Sometimes if you move the flycutter off center, the finish will improve some, but not by much.

Tom