Aluminum mig welding a stripped/cracked hole.
#6
(04-25-2012, 07:56 AM)mikecwik Wrote: when in a hole how do you keep the arc from rising up the walls faster than the hole is being filled?

I drilled the holes bigger and then wobbled the bit making the holes bigger at the top than the bottom. If not they would have just filled right over and none in the bottom where the extra aluminum was needed...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
RE: Aluminum mig welding a stripped/cracked hole. - by aametalmaster - 05-01-2012, 07:37 PM
RE: Aluminum mig welding a stripped/cracked hole. - by Turbinedoctor - 05-05-2012, 11:36 AM



Users browsing this thread: 1 Guest(s)