MetalworkingFun Forum › Machinery › Lathes v
Advice on carbide insert boring bar

Thread Modes
Advice on carbide insert boring bar
EdK Offline
Whipping Boy
*******
Posts: 8,746
Threads: 314
Joined: Feb 2012
Location: Arizona/Minnesota
#8
01-16-2015, 12:19 PM
(01-16-2015, 08:30 AM)PixMan Wrote: ...
If it's not more than an inch & half or so deep, I just use Micro 100 solid carbide boring bars. They rock!

+2

You can find them on eBay at reasonable prices.

Ed
Reply
Thanks given by:


Messages In This Thread
Advice on carbide insert boring bar - by mike-sid - 01-15-2015, 06:40 PM
RE: Advice on carbide insert boring bar - by EdK - 01-15-2015, 06:46 PM
RE: Advice on carbide insert boring bar - by EdK - 01-16-2015, 06:29 AM
RE: Advice on carbide insert boring bar - by EdK - 01-16-2015, 12:19 PM
RE: Advice on carbide insert boring bar - by EdK - 01-16-2015, 06:00 PM
RE: Advice on carbide insert boring bar - by EdK - 01-16-2015, 09:54 PM



Users browsing this thread: 1 Guest(s)