I need to make a small repair on my Franken Mill

[mike-sid]

(01-25-2015, 10:32 AM)Dr Stan Wrote:

(01-25-2015, 10:30 AM)Sunset Machine Wrote: I'd get rid of that roll pin and make (yeppers!) one from solid.

or IMHO better yet use a taper pin.  You will need to use a taper pin reamer (beg, borrow, buy, or midnight requisition).

Ok ok. Good point guys. Even though the roll pin will take the hand tight pressure, you are right. I was in Sears hardware and bought an assortment of taper pins and see if I have the right size reamer or buy one. I don't want to be a hack, and do the job right.
What I kind or reamer will work on drill rod?