Leveling?

[Wongster]

Hi Dave,

The "holes 12" are the 2 slots I mentioned, one below the spindle and one at the tailstock end. They are in use for the chip tray. I was hoping for some thread holes on the chip tray to simply fix up some feet. Maybe some rubber feet at the bottom of the chip tray would work.

On the chip tray, there are 2 tube like holes:

Spindle end, below gearbox cover


Behind Tailstock end


I think I should be able to do this. Use some elbow grease to remove the lathe from the chip tray, mark the 2 holes on the wooden board to drill through for bolts, and install the the chip tray with the rubber feet beneath.

Regards,
Wong