MetalworkingFun Forum › Machinery › Lathes v
Leveling?

Thread Modes
Leveling?
DaveH Offline
Child of the 60's
******
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
#14
04-08-2012, 07:57 PM (This post was last modified: 04-08-2012, 07:58 PM by DaveH.)
Hi Wong,

I think that is the correct way to do it.

Those tubes allow you screw/ bolt the chip tray down to the board, so the coolant will not seep through. The screw/bolt down to stop it rattling. Smile

The chip tray should be flat on the board - no rubber feet in between the chip tray and the board.

Smiley-eatdrink004
DaveH
Reply
Thanks given by:


Messages In This Thread
Leveling? - by Wongster - 04-08-2012, 10:02 AM
RE: Leveling? - by aametalmaster - 04-08-2012, 10:17 AM
RE: Leveling? - by DaveH - 04-08-2012, 10:57 AM
RE: Leveling? - by Wongster - 04-08-2012, 11:12 AM
RE: Leveling? - by DaveH - 04-08-2012, 11:16 AM
RE: Leveling? - by DaveH - 04-08-2012, 11:29 AM
RE: Leveling? - by Bogstandard - 04-08-2012, 12:05 PM
RE: Leveling? - by DaveH - 04-08-2012, 12:36 PM
RE: Leveling? - by Wongster - 04-08-2012, 01:24 PM
RE: Leveling? - by DaveH - 04-08-2012, 02:04 PM
RE: Leveling? - by Wongster - 04-08-2012, 06:25 PM
RE: Leveling? - by DaveH - 04-08-2012, 07:04 PM
RE: Leveling? - by Wongster - 04-08-2012, 07:32 PM
RE: Leveling? - by DaveH - 04-08-2012, 07:57 PM
RE: Leveling? - by Rickabilly - 09-23-2012, 10:12 AM
RE: Leveling? - by Hopefuldave - 09-23-2012, 06:00 PM
RE: Leveling? - by Wongster - 09-24-2012, 11:33 AM
RE: Leveling? - by Rickabilly - 09-24-2012, 01:12 PM
RE: Leveling? - by stevec - 09-24-2012, 02:56 PM
RE: Leveling? - by Wongster - 09-24-2012, 05:38 PM
RE: Leveling? - by Rickabilly - 09-25-2012, 04:29 AM
RE: Leveling? - by stevec - 09-24-2012, 05:42 PM



Users browsing this thread: 1 Guest(s)