new to turning and milling!
#1
hi too all, new to the game.
first little milling project... thumbs up or thumbs down?
40mmx40mm


   
Reply
Thanks given by:
#2
Looks good to me.  Thumbsup 

Now you just need another one and then paint them appropriately.  Big Grin 
Willie
Reply
Thanks given by:
#3
Looks good to me as well. Thumbsup 

You should be pleased and proud of your achievement Smile 
Smiley-eatdrink004 
DaveH
Reply
Thanks given by:
#4
Is it loaded? Big Grin
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#5
(02-05-2015, 06:33 PM)TomG Wrote: Is it loaded? Big Grin

Don't confuse this post with one of Steve's Tom.

Oh, wait..... you were talking about the DIE??  Big Grin
Willie
Reply
Thanks given by:
#6
thanks guys.

no TomG it isn't.... it won't be getting rolled anyway haha, i don't want to mark it!
Reply
Thanks given by:
#7
couple of bits produced, little scuff on the pin punch 6mm shaft


Attached Files Thumbnail(s)
       
Reply
Thanks given by:
#8
Smiley-signs107

Just need 1 more.
Steve S
Check out MyShopNotes on youtube.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)