mill head to table align'
#8
@Shawn - do you mean brake rotor/disk?

If you plan to use the rotor, use a tenths indicator to discover if the rotor faces are actually parallel. Move the rotor under a stationary indicator.

Used rotors are probably not going to be flat or parallel. A new one should be, a freshly-turned one might be.
Reply
Thanks given by:


Messages In This Thread
mill head to table align' - by chanse - 02-08-2015, 09:02 PM
RE: mill head to table align' - by Highpower - 02-09-2015, 12:46 AM
RE: mill head to table align' - by fix - 02-09-2015, 11:13 AM
RE: mill head to table align' - by Vinny - 02-09-2015, 03:07 PM
RE: mill head to table align' - by Dr Stan - 02-09-2015, 11:21 PM
RE: mill head to table align' - by chanse - 02-11-2015, 08:55 PM
RE: mill head to table align' - by Shawn - 02-19-2015, 01:56 AM
RE: mill head to table align' - by Roadracer_Al - 02-19-2015, 02:08 AM
RE: mill head to table align' - by Shawn - 02-19-2015, 10:14 AM
RE: mill head to table align' - by Arbalest - 02-19-2015, 05:58 AM
RE: mill head to table align' - by CNCAZ - 10-29-2015, 09:47 AM
RE: mill head to table align' - by dallen - 10-29-2015, 11:59 AM



Users browsing this thread: 1 Guest(s)