do I "need" a fly cutter, if I have a face mill

Hello There, Guest! Register

Thread Modes

do I "need" a fly cutter, if I have a face mill

Sunset Machine Offline

Offline

Junior

Posts: 716
Threads: 32
Joined: Apr 2012
Location: Washington, USA

#8

02-16-2015, 08:51 AM

Here's mine. Never mind the center hole, it was arbor mounted but I needed an adjustable one and so here it is. Rotfl

Rotfl

Attached Files Thumbnail(s)

Reply

« Next Oldest | Next Newest »

Messages In This Thread

do I "need" a fly cutter, if I have a face mill - by mike-sid - 02-15-2015, 08:02 PM

RE: do I "need" a fly cutter, if I have a face mill - by EdK - 02-15-2015, 08:07 PM

RE: do I "need" a fly cutter, if I have a face mill - by DaveH - 02-15-2015, 08:12 PM

RE: do I "need" a fly cutter, if I have a face mill - by f350ca - 02-15-2015, 11:15 PM

RE: do I "need" a fly cutter, if I have a face mill - by Arbalest - 02-16-2015, 05:21 AM

RE: do I "need" a fly cutter, if I have a face mill - by Arbalest - 02-16-2015, 05:25 AM

RE: do I "need" a fly cutter, if I have a face mill - by Mayhem - 02-16-2015, 06:25 AM

RE: do I "need" a fly cutter, if I have a face mill - by Sunset Machine - 02-16-2015, 08:51 AM

RE: do I "need" a fly cutter, if I have a face mill - by PixMan - 02-16-2015, 08:31 PM

RE: do I "need" a fly cutter, if I have a face mill - by Micktoon - 02-17-2015, 03:30 AM

RE: do I "need" a fly cutter, if I have a face mill - by PixMan - 02-17-2015, 08:49 AM

RE: do I "need" a fly cutter, if I have a face mill - by mike-sid - 02-17-2015, 07:10 AM

RE: do I "need" a fly cutter, if I have a face mill - by EdK - 02-17-2015, 08:03 AM

RE: do I "need" a fly cutter, if I have a face mill - by Mayhem - 02-17-2015, 08:07 AM

RE: do I "need" a fly cutter, if I have a face mill - by EdK - 02-17-2015, 08:10 AM

RE: do I "need" a fly cutter, if I have a face mill - by Mayhem - 02-17-2015, 07:25 AM

RE: do I "need" a fly cutter, if I have a face mill - by mike-sid - 02-17-2015, 07:51 AM

RE: do I "need" a fly cutter, if I have a face mill - by mike-sid - 02-18-2015, 10:05 PM

Users browsing this thread: