More lathe gadgets

[Vinny]

Here it is.  I still need to find a magnet around here.  I have plenty of hard drive magnets but they're still in the hard drives.   I also need to add a bit more plastic to the bottom, it's a bit thin in the middle as you can see. It measures 1.125" x 0.750" and the little hole in the side has a 6-32 set screw in it holding on to the DI.  I did it that way 'cuze I have a DTI that's smaller in diameter and the tab on the back is smaller than these.

Thinking about it now, what I should've done was just made a plastic cylinder and milled the hole for the DI tab afterward.

Seeing how it came out, I'm going to make a mold of it so I can make more.