03-03-2015, 05:41 PM
Billy,
I have a couple of questions about the prints. I've attached images to help clarify what I'm trying to ask. On what I'll call the master page for the frame back you have a dimension at the bottom dimensioning two holes 3.625" from the bottom of the part. On another page called "Bushing Block Holes" those holes appear to be dimensioned 2.375 from the bottom of the part. Either I'm not interpreting the drawings correctly, probably so, or there might be an error.
Another question is about the three 6-32 holes that are around the 1.5" through hole in that same part. Are those tapped holes or clearance holes? Either way, they are going to cut into the 1.5" hole. Is that your intention?
Ed
I have a couple of questions about the prints. I've attached images to help clarify what I'm trying to ask. On what I'll call the master page for the frame back you have a dimension at the bottom dimensioning two holes 3.625" from the bottom of the part. On another page called "Bushing Block Holes" those holes appear to be dimensioned 2.375 from the bottom of the part. Either I'm not interpreting the drawings correctly, probably so, or there might be an error.
Another question is about the three 6-32 holes that are around the 1.5" through hole in that same part. Are those tapped holes or clearance holes? Either way, they are going to cut into the 1.5" hole. Is that your intention?
Ed