Billy G's Die Filer

[EdK]

(03-07-2015, 02:55 PM)Bill Gruby Wrote: You have three holes, two at .250, one at .562. The first (.250) is .625 from the top edge. The second (.562) is .750 down from that one. The third (.250) is .750 down from the last one. That should leave .312 of stock between each hole ????????????????????

"Billy G"

The print I got from you dimensions the larger hole, .750 on the print, and the two .250" holes at 1.062 from the top edge. I understand the changing of the positions of the two 1/4" holes but didn't know the location of the now .562 hole had changed. I went through this whole thread and nowhere is it mentioned that this dimension had changed, or else I'm blind and can't see it.

I'll change the dimensions to what you've stated above.

Ed