A Boma
#11
(03-19-2015, 04:45 PM)EdK Wrote: You're pushing your luck Dave. Smiley-nono

Ed

I know but it is good fun Rotfl
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#12
And these,

   

Perfect she said
Smiley-dancenana  Smiley-dancenana  Smiley-dancenana
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#13
That looks like a waste basket to me. 17428

Ed
Reply
Thanks given by:
#14
(03-19-2015, 05:13 PM)EdK Wrote: That looks like a waste basket to me.  17428

Ed

Don't you start  Rotfl  Rotfl   Rotfl
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#15
I'm not too keen on them, the paint burns off, then they go rusty and look a mess.
Stainless steel - too expensive.
Smiley-eatdrink004 
DaveH
Reply
Thanks given by:
#16
A stainless steel one may look nice.

   

Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#17
Might be a reason to buy a spot welder for the stainless.

Then when it will only do up to 1/8", you could say, you need to rivet it in thicker stock for safety reasons, so send for some stainless rod.

When that causes you to hit your thumb (just use some purple and black magic marker) tell her a TIG rig is too expensive, mybe you should just give up........unless?
Reply
Thanks given by:
#18
Riveting - that's too many holes to drill Big Grin 
Smiley-eatdrink004 
DaveH
Reply
Thanks given by:
#19
Good point -- add that to the list of problems that will get you a TIG in the end.....
Reply
Thanks given by:
#20
I'm trying to find out if I can just stick weld it?

http://metalworkingfun.com/showthread.php?tid=2590

Smiley-eatdrink004 
DaveH
Reply
Thanks given by:




Users browsing this thread: 3 Guest(s)