04-05-2015, 12:20 PM
Thanks, Ed. Whish I had someone close that understood this stuff and could explain it to me.
A programming manual is great, but if there's not enough examples to use and try, it doesn't help.
Just spent an hour trying to get the keypad to input a # and display it. I copied the keypad stuff from the sketch in question, as I have that part right, and make it display an input. No go.
Chuck
A programming manual is great, but if there's not enough examples to use and try, it doesn't help.
Just spent an hour trying to get the keypad to input a # and display it. I copied the keypad stuff from the sketch in question, as I have that part right, and make it display an input. No go.
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
The difficult takes me a while, the impossible takes a little longer.