Sector Arms for my dividing head
#1
I am building a dividing head from a new 40:1 gearbox and i needed some fancy sector arms made. So i made this simple fixture to make a nice round end. I cut the flats on my shaper ( i have a vid someplace) and then rounded the ends with my sander. I just sanded flush to the bushing that was cut the right size with a bolt holding everything together. I will post some pics of the DH build...Bob


Attached Files Thumbnail(s)
           
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:
#2
Bob,

They came out very nice Smiley-signs107
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#3
Here is a little vid of my SBL shaper cutting the arms. That thing runs like a swiss watch...Bob
http://s110.photobucket.com/albums/n86/a...per004.mp4
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:
#4
(04-11-2012, 05:31 PM)aametalmaster Wrote: Here is a little vid of my SBL shaper cutting the arms. That thing runs like a swiss watch...Bob
http://s110.photobucket.com/albums/n86/a...per004.mp4

Shapers are so mesmerizing to watch. Smile

Ed
Reply
Thanks given by:
#5
HI a job well dun DroolDrool
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)