MetalworkingFun Forum › Machining › General Metalworking Discussion v
Grafting feedscrew (Q from a new guy)

Thread Modes
Grafting feedscrew (Q from a new guy)
f350ca Offline
Senior
*****
Posts: 3,002
Threads: 51
Joined: Apr 2012
Location: Ontario
The following 1 user Likes f350ca's post:
EdK (04-30-2015)
#45
04-30-2015, 08:44 AM
Calculating the shear strength of a pin is easy enough, the tricky thing would be determining the strength of the weakest part in the gear train behind it.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Grafting feedscrew (Q from a new guy) - by Pete O - 04-24-2015, 07:10 AM
RE: Grafting feedscrew (Q from a new guy) - by f350ca - 04-30-2015, 08:44 AM



Users browsing this thread: 2 Guest(s)