CCMT Tool Holder
#1
Does anyone know of a source for a CCMT tool holder that can make use of the 100 degree corners for 32.XX sized inserts? I have one for the smaller 21.XX inserts but haven't found one for the larger inserts.

Ed
Reply
Thanks given by:
#2
Have a look at the ToolMex web site.
Hunting American dentists since 2015.
Reply
Thanks given by:
#3
(05-02-2015, 10:14 PM)Mayhem Wrote: Have a look at the ToolMex web site.

No luck there. Sadno

Ed
Reply
Thanks given by:
#4
I've checked with Mitsubishi, NTK and Kyocera, nothing. I'm not saying someone doesn't have it, but if those three who specialize in small screw-down insert holders don't have it, you aren't going to have an easy time of it.

What's the maker and designation of the one you do have?
Reply
Thanks given by:
#5
Thanks for checking Ken. The one I have is a Micro 100. They only make them for the smaller insert size though.

Ed
Reply
Thanks given by:
#6
You've got a mill Ed...

I did check the Toolmex site and they do them for negative inserts only. I knew I had seen them there.
Hunting American dentists since 2015.
Reply
Thanks given by:
#7
(05-03-2015, 10:43 AM)Mayhem Wrote: You've got a mill Ed...
...

Not yet. Big Grin

Ed
Reply
Thanks given by:
#8
1/2 a mill???
Hunting American dentists since 2015.
Reply
Thanks given by:
#9
SECO has one, but I didn't bother to register just to find out how much they cost.  Blush 

https://www.store.secotools.com/webapp/w...Term=13316
Willie
Reply
Thanks given by: EdK
#10
(05-03-2015, 08:11 PM)Highpower Wrote: SECO has one, but I didn't bother to register just to find out how much they cost.  Blush 

https://www.store.secotools.com/webapp/w...Term=13316

$96
jack
Reply
Thanks given by: EdK




Users browsing this thread: 1 Guest(s)