05-16-2015, 02:33 PM
if the ball turner won't reach the work because the cross slide won't travel far enough for the bit to reach the work.
Take a piece of flat bar long enough to fix it and drill two hole in one end so you can bolt it onto the cross slide where the compound attaches, the tap two holes in the other end to bolt the ball turner too.
DA
Take a piece of flat bar long enough to fix it and drill two hole in one end so you can bolt it onto the cross slide where the compound attaches, the tap two holes in the other end to bolt the ball turner too.
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!