05-16-2015, 11:50 PM
(05-16-2015, 02:16 PM)Vinny Wrote: You may have to use a longer piece of round to make your ball so it sticks out of the chuck farther.
Hello there VINNY
Sorry Pal, we not with U
Moving across the saddle, not parallel to the bedways is our problem. The present mounting in the existing Toolpost holes is where the problem's at - the Ball Turner just does not reach close enough to the chuck from that position. By extending a round bar further out the Chuck U are giving me a lateral movement of the workpiece, whereas we need to get closer to the centre point of the Chuck.
Hope we have explained ourselves correctly
aRM