05-27-2015, 10:32 PM
Will the 4 HP work as the rotary supply? And will the 3 HP fit into the mill? I replaced the 4 HP 440 volt motor that came with my mill with a 3 HP single-phase. That's the setup that cut the 1" by 1/2" slot in one pass. You might already have the parts you need, if the voltages are right.
Mike
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.