Cantek 1440, Birmingham, Wilton CT 1440, and others Rebuild
#26
Those are very helpful links Ed. Maybe I'm looking at that picture wrong but I think the gear in the picture Mark posted that is worn out is number 335 in the diagram, not the worm gear number 303. However, since those 2 gears are in mesh I think I would replace them both.
johnncyc14, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:


Messages In This Thread
RE: Cantek 1440, Birmingham, Wilton CT 1440, and others Rebuild - by johnnyc14 - 07-10-2015, 06:49 AM



Users browsing this thread: 3 Guest(s)