Cantek 1440, Birmingham, Wilton CT 1440, and others Rebuild

[turbo711]

Thanks for the offer again Johnnyc14. I think I will try to turn this one myself with the toolpost like it is. I also need to make a new top washer for it with a smaller hole. If I tighten it down real good and make small passes, it should be okay. I have to do some machining sometime instead of getting you guys to do everything!

I know it looks over sized, but if I only mount one holder it doesn't look too bad. I also might swap it over to the CT1440G later, I don't know yet. I think there are 3 more holders including a parting tool holder as well. I kinda want to keep it. It looks mean .

Mark