08-08-2015, 06:48 PM
Would be best if the wrist pin was hollow. If the end is simply faced it may rock if slightly convex or dirt gets under the middle. I'd expect they are pretty hard, so recessing the end might be difficult.
Can't see needing it hardened, if you turned one between centers, and faced the edges of the ends. Then undercut the middle while in a chuck you should have one accurate enough for anything we'd ever do.
Ones also been on my list.
Can't see needing it hardened, if you turned one between centers, and faced the edges of the ends. Then undercut the middle while in a chuck you should have one accurate enough for anything we'd ever do.
Ones also been on my list.
Free advice is worth exactly what you payed for it.
Greg
Greg