08-18-2015, 11:00 AM
Not so far fetched of an idea. My Brown & Sharpe has a threaded spindle nose. With a four-jaw on there that thing can grunt.
Large diameters can mount to a faceplate, RPM permitting. The toolbit can be at the bottom (6 o'clock) and feed by the knee elevator, no need to block it up high at all. If you have it near the 7 o'clock position there is a 1:1 ratio on the diameter to the table feed.
Large diameters can mount to a faceplate, RPM permitting. The toolbit can be at the bottom (6 o'clock) and feed by the knee elevator, no need to block it up high at all. If you have it near the 7 o'clock position there is a 1:1 ratio on the diameter to the table feed.