RF-30 mill drill
#8
I get it - this is your baby. Kinda brings a tear to my eye. Somewhere I saw one of these with the head laying sideways on the table for driving a boring bar. The bar itself was attached to a loader bucket in the usual manner but coupled through u-joints and a shaft to the dead mill/drill in the back of a truck.
Reply
Thanks given by:


Messages In This Thread
RF-30 mill drill - by stevec - 08-30-2015, 08:10 AM
RE: RF-30 mill drill - by ieezitin - 08-30-2015, 09:18 AM
RE: RF-30 mill drill - by Sunset Machine - 08-30-2015, 09:41 AM
RE: RF-30 mill drill - by stevec - 08-30-2015, 02:50 PM
RE: RF-30 mill drill - by Sunset Machine - 08-31-2015, 08:36 AM
RE: RF-30 mill drill - by dallen - 08-31-2015, 09:19 AM
RE: RF-30 mill drill - by stevec - 08-31-2015, 11:50 AM
RE: RF-30 mill drill - by Sunset Machine - 08-31-2015, 12:52 PM
RE: RF-30 mill drill - by stevec - 08-31-2015, 02:31 PM
RE: RF-30 mill drill - by Sunset Machine - 08-31-2015, 03:36 PM
RE: RF-30 mill drill - by Roadracer_Al - 08-31-2015, 02:36 PM
RE: RF-30 mill drill - by ieezitin - 08-31-2015, 04:42 PM
RE: RF-30 mill drill - by stevec - 09-01-2015, 06:02 AM



Users browsing this thread: 1 Guest(s)