MetalworkingFun Forum › Machining › How-To's v
Woodruff cutter making

Thread Modes
Woodruff cutter making
DaveH Offline
Child of the 60's
******
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
#9
09-13-2015, 07:23 AM
When I was an apprentice a couple of years ago Big Grin  we went around the Dormer Drill factory in Sheffield (UK). The main drill body was HSS and the shank was med/high carbon steel the two blanks were butt welded together. Although the shank is softer than HSS it is hardened slightly at the factory, and because it is a med/high carbon steel it is possible to harden it.
Which is what Rob did.
Smiley-eatdrink004 
DaveH
Reply
Thanks given by:


Messages In This Thread
Woodruff cutter making - by RobWilson - 09-11-2015, 09:38 AM
RE: Woodruff cutter making - by EdK - 09-11-2015, 10:37 AM
RE: Woodruff cutter making - by Highpower - 09-11-2015, 04:03 PM
RE: Woodruff cutter making - by Roadracer_Al - 09-11-2015, 11:27 AM
RE: Woodruff cutter making - by RobWilson - 09-11-2015, 11:44 AM
RE: Woodruff cutter making - by krv3000 - 09-11-2015, 04:24 PM
RE: Woodruff cutter making - by PixMan - 09-12-2015, 10:26 PM
RE: Woodruff cutter making - by RobWilson - 09-13-2015, 12:51 AM
RE: Woodruff cutter making - by DaveH - 09-13-2015, 07:23 AM
RE: Woodruff cutter making - by RobWilson - 09-13-2015, 07:49 AM
RE: Woodruff cutter making - by Mayhem - 09-13-2015, 08:03 AM



Users browsing this thread: 1 Guest(s)