5C collet nut
#1
                       
Collet nut built for end mill holder.
Not pretty but worked very well.
Scrap socket used to tighten new nut.


Attached Files Thumbnail(s)
   
Heavy Metal Illness
Reply
Thanks given by:
#2
hi I have one of them tool holders never had a go with it is it good for sharpening up the cutters
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#3
KRV3000.
Have not tried it yet as I think its to be used with a surface grinder.
It was picked up for a song because of missing parts.
May be possible  used with a Vertical or Horizontal Mill and Diamond wheel
Once I get the shop put back together I will try it.
Heavy Metal Illness
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)