Project Filing machine build
#13
I'm planning to travel from Tennessee to New York for the holiday season. I might just make a side trip to Pine Grove Mills, PA, and pick up a kit. That is unless someone comes up with a "bar stock, bail twine and small fury animals..." design they're willing to share...

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Filing machine build - by marfaguy - 11-15-2015, 10:44 PM
RE: Filing machine build - by marfaguy - 11-15-2015, 10:55 PM
RE: Filing machine build - by f350ca - 11-16-2015, 12:15 AM
RE: Filing machine build - by EdK - 11-16-2015, 06:41 AM
RE: Filing machine build - by Highpower - 11-16-2015, 10:57 AM
RE: Filing machine build - by chucketn - 11-16-2015, 11:01 AM
RE: Filing machine build - by Highpower - 11-16-2015, 06:24 PM
RE: Filing machine build - by rleete - 11-16-2015, 07:11 PM
RE: Filing machine build - by Highpower - 11-17-2015, 10:07 AM
RE: Filing machine build - by Vinny - 11-16-2015, 07:31 PM
RE: Filing machine build - by Highpower - 11-16-2015, 10:03 PM
RE: Filing machine build - by Vinny - 11-16-2015, 10:27 PM
RE: Filing machine build - by Mayhem - 11-17-2015, 06:55 AM
RE: Filing machine build - by chucketn - 11-17-2015, 07:23 AM
RE: Filing machine build - by Highpower - 11-17-2015, 10:14 AM
RE: Filing machine build - by dallen - 11-17-2015, 09:03 AM
RE: Filing machine build - by marfaguy - 11-23-2015, 09:15 PM
RE: Filing machine build - by marfaguy - 11-28-2015, 09:58 PM
RE: Filing machine build - by Dr Stan - 12-11-2015, 11:45 AM
RE: Filing machine build - by marfaguy - 12-13-2015, 07:58 PM
RE: Filing machine build - by Roadracer_Al - 12-12-2015, 03:14 PM
RE: Filing machine build - by marfaguy - 12-13-2015, 08:02 PM
RE: Filing machine build - by marfaguy - 12-24-2015, 09:47 PM
RE: Filing machine build - by Highpower - 12-25-2015, 05:47 AM
RE: Filing machine build - by Roadracer_Al - 12-25-2015, 12:49 PM
RE: Filing machine build - by Highpower - 12-25-2015, 01:56 PM
RE: Filing machine build - by ncollar - 01-21-2016, 10:50 PM



Users browsing this thread: 2 Guest(s)