Machining Nylon-Unattended
#7
By "sharp" I was referring to the edge not the tip radius. I didn't say it very well though. Blush

Ed
Reply
Thanks given by:


Messages In This Thread
Machining Nylon-Unattended - by wrustle - 11-17-2015, 07:04 PM
RE: Machining Nylon-Unattended - by EdK - 11-17-2015, 07:08 PM
RE: Machining Nylon-Unattended - by wrustle - 11-17-2015, 07:23 PM
RE: Machining Nylon-Unattended - by wrustle - 11-17-2015, 07:24 PM
RE: Machining Nylon-Unattended - by EdK - 11-17-2015, 07:29 PM
RE: Machining Nylon-Unattended - by wrustle - 11-17-2015, 08:03 PM
RE: Machining Nylon-Unattended - by EdK - 11-18-2015, 06:40 AM
RE: Machining Nylon-Unattended - by Mayhem - 11-18-2015, 08:34 AM



Users browsing this thread: 1 Guest(s)