09-04-2015, 04:44 PM
It seems like it always takes at least twice as long to do a project than I estimate so I didn't get nearly as much done today as I wanted to. 
But I'm still on track for the test run on Monday so I'm not going to sweat it, literally since it's so hot and humid right now.
Ed
Board all wired up as far as I can go with it.
Those 4 terminals have 220VAC on them so I attached a piece of plastic in front of them as a guard and also cut a piece to form a right angle at the top so nothing can fall on them from above since the board will be attached to the wall. That piece of key stock is holding it in place while the silicon rubber sealant adhesive dries.
Next I have to make these panels which hold the switches and potentiometer.
But I'm still on track for the test run on Monday so I'm not going to sweat it, literally since it's so hot and humid right now.
Ed
Board all wired up as far as I can go with it.
Those 4 terminals have 220VAC on them so I attached a piece of plastic in front of them as a guard and also cut a piece to form a right angle at the top so nothing can fall on them from above since the board will be attached to the wall. That piece of key stock is holding it in place while the silicon rubber sealant adhesive dries.
Next I have to make these panels which hold the switches and potentiometer.