a eclipse pin chuck sensertive drill atachment

[krv3000]

hi  I have bin biz with other things but when time allowed I managed to get most of the metal work dun sos not that many pics I got sum 6mm thick gage plate and marked it out then drilled two 10mm hols then cut the middle out  with a hacksaw then driest it up with a file sos no pics of the next bit cut the mane part out then drilled and reemd m3 two pivot points then cut out the bottom slot then file it to 6mm then with a nuther peace drilled 9.8 then reemd to 10mm this is to go on to the front of the taper then drilled 2.8 then reemd 3mm for the pivot then made the link 6mm by 6mm did not have any bar the same diameter for the handle so mad it out of a long m8 bolt with the front tapered then silver soldered it to the front fork right pics