MetalworkingFun Forum › Machining › Projects v
Electronics Question (again...)

Thread Modes
Electronics Question (again...)
EdK Offline
Whipping Boy
*******
Posts: 8,739
Threads: 313
Joined: Feb 2012
Location: Arizona/Minnesota
#21
03-19-2016, 12:14 PM
(03-18-2016, 11:08 PM)Highpower Wrote: Now I just have to hope I guessed at ordering the correct mating connector and pins to connect the switch to.

Willie,

Which parts did you order? I can tell you if they're the correct ones. That Molex connector in the picture is one we use at work so I can check on the proper part numbers for you.

Ed
Reply
Thanks given by:


Messages In This Thread
Electronics Question (again...) - by Highpower - 03-11-2016, 01:40 PM
RE: Electronics Question (again...) - by EdK - 03-11-2016, 05:01 PM
RE: Electronics Question (again...) - by f350ca - 03-11-2016, 06:16 PM
RE: Electronics Question (again...) - by Vinny - 03-11-2016, 07:28 PM
RE: Electronics Question (again...) - by pepi - 03-12-2016, 08:24 AM
RE: Electronics Question (again...) - by EdK - 03-11-2016, 07:43 PM
RE: Electronics Question (again...) - by Mayhem - 03-11-2016, 07:51 PM
RE: Electronics Question (again...) - by Vinny - 03-11-2016, 07:51 PM
RE: Electronics Question (again...) - by EdK - 03-12-2016, 08:35 AM
RE: Electronics Question (again...) - by pepi - 03-12-2016, 10:53 PM
RE: Electronics Question (again...) - by Mayhem - 03-12-2016, 09:27 AM
RE: Electronics Question (again...) - by EdK - 03-12-2016, 03:04 PM
RE: Electronics Question (again...) - by Mayhem - 03-12-2016, 07:27 PM
RE: Electronics Question (again...) - by pepi - 03-19-2016, 07:23 AM
RE: Electronics Question (again...) - by EdK - 03-19-2016, 12:14 PM
RE: Electronics Question (again...) - by EdK - 03-19-2016, 03:23 PM



Users browsing this thread: 1 Guest(s)