LIL' HOGGERS
#10
Hi aRM - are you going to use this mill up to a 90° shoulder or only ever face milling? The reason Ken asked is because a lot of face mills use inserts that will not enable you to mill up to a 90° shoulder.

If you take a look at the picture of the three mills in your original post, only the last one (triangular insert) would allow this.

You can face mill with a shoulder mill but you cannot always shoulder mill with a face mill.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
LIL' HOGGERS - by aRM - 04-12-2016, 08:56 AM
RE: LIL' HOGGERS - by johnnyc14 - 04-12-2016, 11:19 AM
RE: LIL' HOGGERS - by aRM - 04-12-2016, 11:44 AM
RE: LIL' HOGGERS - by schor - 04-12-2016, 03:15 PM
RE: LIL' HOGGERS - by the penguin - 04-12-2016, 07:04 PM
RE: LIL' HOGGERS - by PixMan - 04-14-2016, 01:22 PM
RE: LIL' HOGGERS - by aRM - 04-14-2016, 02:09 PM
RE: LIL' HOGGERS - by PixMan - 04-15-2016, 05:39 AM
RE: LIL' HOGGERS - by aRM - 04-15-2016, 07:55 AM
RE: LIL' HOGGERS - by Mayhem - 04-15-2016, 07:06 PM
RE: LIL' HOGGERS - by aRM - 04-16-2016, 12:25 AM
RE: LIL' HOGGERS - by PixMan - 04-15-2016, 08:05 PM
RE: LIL' HOGGERS - by aRM - 04-16-2016, 08:30 AM
RE: LIL' HOGGERS - by aRM - 04-16-2016, 08:54 AM
RE: LIL' HOGGERS - by PixMan - 04-17-2016, 07:28 AM
RE: LIL' HOGGERS - by aRM - 04-17-2016, 08:34 AM
RE: LIL' HOGGERS - by PixMan - 04-17-2016, 10:30 AM
RE: LIL' HOGGERS - by aRM - 04-17-2016, 11:55 AM
RE: LIL' HOGGERS - by PixMan - 04-18-2016, 08:31 AM
RE: LIL' HOGGERS - by aRM - 04-18-2016, 10:36 AM
RE: LIL' HOGGERS - by aRM - 04-18-2016, 11:48 AM
RE: LIL' HOGGERS - by aRM - 04-18-2016, 02:22 PM
RE: LIL' HOGGERS - by PixMan - 04-18-2016, 02:32 PM
RE: LIL' HOGGERS - by aRM - 04-19-2016, 01:19 AM



Users browsing this thread: