Surface plate in a roll around tool box

Hello There, Guest! Register

Thread Modes

Surface plate in a roll around tool box

the penguin Offline

Offline

Junior

Posts: 482
Threads: 89
Joined: Oct 2012
Location: camillus (syracuse), ny

#19

10-03-2016, 06:05 PM

I have a surface plate on a roll around tool box bottom, but the laptop sets on the 18" x 18" x 3" Grizzly sourced stone.

jack

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Surface plate in a roll around tool box - by JScott - 05-04-2016, 11:49 AM

RE: Surface plate in a roll around tool box - by Highpower - 05-04-2016, 02:43 PM

RE: Surface plate in a roll around tool box - by pepi - 05-05-2016, 07:53 AM

RE: Surface plate in a roll around tool box - by JScott - 05-05-2016, 08:37 AM

RE: Surface plate in a roll around tool box - by JScott - 06-16-2016, 12:07 PM

RE: Surface plate in a roll around tool box - by EdK - 06-16-2016, 04:20 PM

RE: Surface plate in a roll around tool box - by JScott - 06-17-2016, 08:46 AM

RE: Surface plate in a roll around tool box - by EdK - 06-23-2016, 06:54 AM

RE: Surface plate in a roll around tool box - by JScott - 06-23-2016, 09:16 AM

RE: Surface plate in a roll around tool box - by EdK - 06-23-2016, 11:22 AM

RE: Surface plate in a roll around tool box - by JScott - 06-23-2016, 11:53 AM

RE: Surface plate in a roll around tool box - by zmotorsports - 06-24-2016, 04:21 PM

RE: Surface plate in a roll around tool box - by EdK - 06-30-2016, 09:21 PM

RE: Surface plate in a roll around tool box - by Vinny - 06-30-2016, 09:31 PM

RE: Surface plate in a roll around tool box - by EdK - 06-30-2016, 10:17 PM

RE: Surface plate in a roll around tool box - by JScott - 07-01-2016, 08:47 AM

RE: Surface plate in a roll around tool box - by EdK - 07-01-2016, 09:07 AM

RE: Surface plate in a roll around tool box - by EdK - 10-03-2016, 05:41 PM

RE: Surface plate in a roll around tool box - by the penguin - 10-03-2016, 06:05 PM

RE: Surface plate in a roll around tool box - by f350ca - 10-03-2016, 06:57 PM

RE: Surface plate in a roll around tool box - by EdK - 10-03-2016, 07:38 PM

RE: Surface plate in a roll around tool box - by Pete O - 10-03-2016, 07:08 PM

RE: Surface plate in a roll around tool box - by Vinny - 10-03-2016, 08:31 PM

RE: Surface plate in a roll around tool box - by pepi - 10-03-2016, 10:22 PM

RE: Surface plate in a roll around tool box - by EdK - 10-04-2016, 05:36 AM

RE: Surface plate in a roll around tool box - by pepi - 10-04-2016, 05:52 AM

Users browsing this thread: 1 Guest(s)