taper turning
#9
Nice job on the tapers. Is the steel hot rolled, or just rusty? Or can you tell?

A good way to check your taper is to use a MT socket and some Prussian blue. Just put a light coat of blue on the taper, stick it in the socket and twist. The blue will rub off on the tighter end.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
taper turning - by texx - 05-09-2016, 04:22 AM
RE: taper turning - by Mayhem - 05-09-2016, 06:09 AM
RE: taper turning - by texx - 05-09-2016, 09:41 AM
RE: taper turning - by hexreader - 05-09-2016, 11:51 AM
RE: taper turning - by Roadracer_Al - 05-09-2016, 12:20 PM
RE: taper turning - by hexreader - 05-09-2016, 03:59 PM
RE: taper turning - by Dr Stan - 05-09-2016, 05:28 PM
RE: taper turning - by texx - 05-09-2016, 05:48 PM
RE: taper turning - by TomG - 05-10-2016, 04:42 PM
RE: taper turning - by texx - 05-11-2016, 12:15 AM



Users browsing this thread: 2 Guest(s)