MetalworkingFun Forum › Machining › Welding & Casting v
Aluminum wheel repair.

Thread Modes
Aluminum wheel repair.
aametalmaster Offline
MTLMSTR
****
Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio
#5
07-31-2016, 08:27 AM
(07-31-2016, 07:30 AM)pepi Wrote: Drill a stop hole at the end of the crack?

Greg
No I didn't. The grinder took care if that in the 2nd pic. There actually wasn't a crack left after the grinder cut it out. Now its a giant hole...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
Aluminum wheel repair. - by aametalmaster - 07-30-2016, 01:27 PM
RE: Aluminum wheel repair. - by ieezitin - 07-30-2016, 06:23 PM
RE: Aluminum wheel repair. - by aametalmaster - 07-30-2016, 06:58 PM
RE: Aluminum wheel repair. - by pepi - 07-31-2016, 07:30 AM
RE: Aluminum wheel repair. - by aametalmaster - 07-31-2016, 08:27 AM
RE: Aluminum wheel repair. - by pepi - 07-31-2016, 09:45 PM
RE: Aluminum wheel repair. - by Dr Stan - 07-31-2016, 06:49 PM
RE: Aluminum wheel repair. - by aametalmaster - 08-01-2016, 07:57 AM
RE: Aluminum wheel repair. - by aametalmaster - 08-01-2016, 07:59 AM
RE: Aluminum wheel repair. - by Dr Stan - 08-01-2016, 11:26 PM
RE: Aluminum wheel repair. - by aametalmaster - 08-02-2016, 08:12 PM



Users browsing this thread: 2 Guest(s)