|
How was this part made
|
09-26-2016, 02:55 PM
If I'm to try my hand at machining this, how should I approach it? The aluminum profile I'm using has corners with radius of about 1.5mm. But my 3mm endmill maybe too short for this 60mm pc.
Wongster
http://www.wongstersproduction.com Proud to be a member of MetalworkingFun Forum since Mar 2012. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
How was this part made - by Wongster - 09-25-2016, 11:30 PM
RE: How was this part made - by Mayhem - 09-26-2016, 12:54 AM
RE: How was this part made - by Wongster - 09-26-2016, 03:55 AM
RE: How was this part made - by Mayhem - 09-26-2016, 04:10 AM
RE: How was this part made - by Dr Stan - 09-26-2016, 12:53 PM
RE: How was this part made - by dallen - 09-26-2016, 02:34 PM
RE: How was this part made - by Wongster - 09-26-2016, 02:55 PM
RE: How was this part made - by PixMan - 09-26-2016, 08:39 PM
RE: How was this part made - by Dr Stan - 09-26-2016, 10:55 PM
RE: How was this part made - by Wongster - 09-26-2016, 11:31 PM
RE: How was this part made - by Dr Stan - 09-27-2016, 10:14 AM
|
